pcModz Philippines

PC Modz Philippines (PCMP) is a online community for computer hardware and PC modding enthusiasts.

Project: COOLDAWN - Posted by doki at 03:24 AM

Update: Case Lightings

6 - Superbright Green LED and 470 ohms resistor
1 - prototyping board





I will upload the working circuit later

Giga-MOD Triton - Posted by Rider_2hip at 10:28 AM

heres my project


ang aking G-triton  na babaklasin, huhubaran at pagpipirasuhin just for the sake of MODDING.





Objective:1.to Practice the skill of using different tools and develop patience.

Target points:
a: create a design on the top using different material like acrylic steel etc....


txt to be continued (kakatamad mag type)

i remove the drive bay clip



cut the diamond shape  sa flooring ng casing, also time to fix the irregular shape of the hole on the mobo tray,




initial design template(but  i changed the flame orietation lately)



Tools required



First attempt



first flame completion



second flame finished and a bit of sanding is required



before I sand and buff the flames I decided to start the skull



just check the size of the cut off disc before i give him a rest,,



I can't finish the skull design,, some burr set for the die grinder is required, so i started the tribal flame on the lower skull.Worksched to tight ,, just finished cutting the mesh plate thru die grinder






To be continued,,,,,


Please post your comment and suggestion,, I'm still working for the front design and the right side panel,

Thanks

project "Remembrance" - Posted by bloodyvamp at 04:03 AM

1st time to do this..comments are welcome..

Old P3 steel casing from Saudi... about 13 years old na with ONLY a little bit of rust showing..

The Cut
LEFT PANEL

CURVE

RIGHT PANEL


Sanded


The SUN
TOP PANEL


d pa po tapos..will be updating as soon as I start again.

·